User's Manual

Rev. 1 OWA 100 Adapter User Manual 29
September 2010
5. Maintenance/Repair
5.1 Parts
The following replacement parts may be ordered from Honeywell.
Part number Qty. Description
50056644-501 1 REMOTE MOUNTING KIT FOR 1/2 NPT OWA 100 ADAPTER
50056644-502 1 REMOTE MOUNTING KIT FOR M20 OWA 100 ADAPTER
30671907-001 1 PIPE MOUNT BRACKET KIT (SS) FOR MOUNTING OWA 100 ADAPTER
50026010-001 2 3.6V LITHIUM THIONYL CHLORIDE (Li-SOCI2) BATTERY
50026010-002 4 3.6V LITHIUM THIONYL CHLORIDE (Li-SOCI2) BATTERY
50026010-003 10 3.6V LITHIUM THIONYL CHLORIDE (Li-SOCI2) BATTERY
5.2 Replacing the battery
When to replace
When the OWA 100 Adapter displays a LOW BAT message, see OWA 100 Adapter display modes on
page 19, you have 2-4 weeks to replace both batteries before they expire. When batteries are removed or
expired, all OWA 100 Adapter data is retained in the OWA 100 Adapter’s non-volatile memory.
Tools required
 #1 Phillips Screwdriver or 3/16” Slotted Screwdriver
Procedure
ATTENTION
The battery must be replaced only by a trained service technician.
WARNINGS
 Risk of death or serious injury by explosion. Do not open OWA 100
Adapter enclosure when an explosive gas atmosphere is present.
 The battery must not be changed in an explosive gas atmosphere.
 The batteries used in this device may present a risk of fire or chemical
burn if mistreated. Do not recharge, disassemble, heat above 100°C
(212°F), or incinerate.
 When installing the battery, do not snag the battery terminal on the clip
or the battery may be damaged. Do not apply excessive force.
 Do not drop. Dropping the battery may cause damage. If a battery is
dropped, do not install the dropped battery into the OWA 100 Adapter.
Dispose of dropped battery promptly per local regulations or per the
battery manufacturer’s recommendations.
and