User's Guide

4. FDAP Installation
4.3. FDAP installation tasks
34 OneWireless Field Device Access Point User's Guide R200
Honeywell Confidential & Proprietary October 2010
The FDAP can be wall mounted or pole mounted using the hardware mounting kit
supplied with the unit. The FDAP enclosure can be mounted on a 2-inch pole or on a
wall using the appropriate mounting kit.
Pole mounting
When pole mounting the FDAP, you can assemble and install the mounting hardware at
the site. The mounting kit includes the following items.
 Mounting plate
 U-bolts with nuts
 Screws (to attach the FDAP to the mounting plate)
The pole mounting kit comprises a mounting plate, U-bolts and nuts as shown in Figure
3
. When using the mounting plate for pole installation, secure the FDAP to the bracket
using the screws supplied with the bracket kit. The FDAP can be mounted to the left or to
the right of the pole using the same mounting hardware. It can also be mounted inline
with the pole. However, doing so without care can put the integral antennas too close to
the pole and cause RF communication problem. For inline mounting the FDAP integral
antennas must be on top of the mounting pole.
Figure 3 – Pole mounting