User's Manual

6 sensing.honeywell.com
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE 1
32309669
2.2 | Certications and Approvals
See product labels for applicable approvals and ratings.
Table 7. Communication Approvals and Standards
Approval/Item Ratings/Description
Enclosure type IP20
Federal Communications Commission
(FCC)
FCC Part 15.247:
2014
Industry Canada (IC)
Canadian RSS-210:
2010
European Telecommunications Stan-
dards Institute (ETSI)
CE mark
Australian Communications and Media
Authority (ACMA)
C-Tick mark
m WARNING
The WMPR must be installed in accordance with the
requirements specified in this document in order to
comply with the specific Country Communication Agency
requirements. (i.e. FCC, IC, ETSI, ACMA, etc.) See Section
3 as it requires choosing the correct Country Use Code and
thus allowable antenna and/or cable usage.
m WARNING
• The cable length of the customer-supplied dc power
source to the WMPR supply terminals cannot exceed three
(3) meters.
• The WMPR must be used indoors.
• The WMPR must be used inside a cabinet and can only be
accessed during set-up or maintenance.
2.3 | Radio Module Specications
Table 8. Radio Module Specications
Item Specication
Radio module Honeywell RF-PCBa
Wireless standard
WPAN IEEE 802.15.4 Direct Sequence
Spread Spectrum (DSSS), 2.4 GHz
Data rate 250 kbps
Operating frequency ISM 2.4 GHz
Module transmit
power
Country use code “A”
Power level, 11 dBm
Country use code “B”
Power level, 6 dBm
Receive sensitivity
(typ.)
-100 dBm
# of pairing (max.)
Up to 14 Limitless™ inputs can be
paired to a single WMPR
2.4 | Electrical Specications
Table 9. Electrical Specications
Item Specication
Supply voltage 10 Vdc to 30 Vdc
Supply current 500 mA max.
Output type EtherNet/IP™
Termination Cage-clamp connector block
m WARNING
The cable length of the customer-supplied dc power source
to the WMPR’s supply terminals cannot exceed three (3)
meters.
2.5 | Operational Characteristics
2.5.1 | Update Rate vs. Node Quantity
To ensure suitable performance the tables below define the
maximum number of nodes that are allowed with all nodes being
at the defined Update Rate:
Table 10. WPS Series Sensors Update Rate
Update Rate (seconds) # of Nodes
0.1 4
0.25, 0.5 6
> 1 14
Table 11. WBX Series Switches Update Rate
Update Rate (seconds) # of Nodes
> 1 14
Limitless™ WLS, WGLA, WOI Series switches cannot have the
update rate changed and are factory set at 30 seconds; number
of nodes: 14.