User's Manual

8 sensing.honeywell.com
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE 1
32309669
2.10.2 | Industry Canada (IC) Compliance
Statements
• To reduce potential radio interference to other users, the
antenna type and its gain should be chosen so that the
equivalent isotropic radiated power (EIRP) is not more
than that permitted for successful communication.
• Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
• This Class A digital apparatus has been tested and
found to comply with Canadian RSS-210:2010.
• This radio transmitter (identify device by certification
number) has been approved by Industry Canada to
operate with the antenna types listed below with the
maximum permissiable gain indicated. Antenna types
not included in this list, have a gain greater than the
maximum gain indicated for that type, are strictly
prohibited for use with this device
- Antenna type approved for use: Omni
- Antenna gain (max.): 9 dBi
• Pour réduire les interférences radio potentielles aux
autres utilisateurs, le type d’antenne et son gain doivent
être choisis de telle sorte que l’équivalent isotrope
puissance rayonnée (PIRE) ne est pas supérieure à
celle permise pour une communication réussie.
• Son fonctionnement est soumis aux deux conditions
suivantes:
(1) ce dispositif ne doit pas causer d’interférences et
(2) cet appareil doit accepter toute interférence, y
compris les interférences qui peuvent causer un
mauvais fonctionnement de l’appareil.
• Cet appareil numérique de classe A est conforme avec
Industrie Canada RSS 210: 2010.
• Cet émetteur radio (appareil identifié par numéro de
certification) a été approuvé par Industry Canada
pour fonctionner avec les types d’antenne répertoriés
ci-dessous et présentant le gain maximal admissible
indiqué. Utiliser des types d’antennes non mentionnés
dans cette liste ou présentant un gain supérieur au
maximum indiqué pour ce type est strictement interdit.
- Type d’antenne approuvé : Toutes directions
- Gain d’antenne (max.) : 9 dBi
2.10.3 | Radio Frequency (RF) Safety
Statements (FCC & IC)
To comply with FCC’s and Industry Canada’s RF exposure
requirements, the following antenna installation and device
operating configurations must be satisfied.
• Remote antenna for this unit must be fixed and mounted
on outdoor permanent structures with a separation
distance between any other antenna(s) of greater than
20 cm [7.87 in] and a separation distance of at least 20
cm [7.87 in] from all persons.
• Furthermore, when using an direct-mount antenna
with the WBX, it must not be co-located with any other
antenna or transmitter device and it must have a
separation distance of at least 20 cm [7.87 in] from all
persons.
2.10.4 | European Restrictions
• Information regarding national restrictions can be
found in document: Annex 1: Non-specific Short
Range Devices, page 6; Oct 07. Documentation may
be found in the document database in the European
Communication’s office.
• http://www.erodocdb.dk/doks/dochistory.
aspx?docintid=1622