User's Manual

Honeywell Sensing and Productivity Solutions 17
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE 1
32309669
Configuration Menu: Allows you to take action to Pair or Purge
Nodes, Change Update Rate or Node LCD Display Time, or Reset
to WMPR to Factory Defaults. Functionality described in Section 8.6
Receiver Detail: Receiver information specic the WMPR device
which includes WMPR FirmWare revision, Part Number, Radio Firm-
Ware revision, Radio MAC ID, and Radio Transmit Power. Function-
ality described in Section 8.7
6.5 | Node Detail
Figure 16. Node Detail Menu
The NODE DETAIL menu (see Figure 16) can be accessed by
touching the “Node Detail” function button as displayed in the
Action Menu (see Figure 15). Once you are in the Node Detail menu
you can choose any of the 14 node numbers by scrolling “Up” or
“Down” to the desired Node number and then touching “Enter”.
You will be able to view three screens of Node Detail information by
touching “Next” or “Prev”.
6.5.1 | Node Detail Menu, Screen 1
Figure 17. Node Detail, Screen 1
A description of the Node Detail “screen 1” information (see Figure
17) is as follows:
Table 16. Node Display and Indication (Screen1)
Display Indication
Not Paired
Limitless™ switch or sensor is not paired to this
Device Address location
Output:
ON or OFF status for a Digital input-Limitless™
switch
Pressure value and Unit type for Analog sen-
sor-Limitless™ pressure sensor
RSSI:
Received Signal Strength Indication-Signal
strength between the WMPR and the Limit-
less™ switch or sensor displayed as EXCEL-
LENT, VERY GOOD, GOOD, LOW, or POOR
Battery
Indicates battery condition as OK or LOW; A
LOW condition normally indicates the battery life
is coming to an end and the battery should be
replaced as soon as possible.
RF Lost
RF Signal between WMPR & Limitless™ switch
or sensor does not exist
6.5.2 | Node Detail Menu, Screen 2
Figure 18. Node Detail, Screen 2
A description of the Node Detail “screen 2” information (see Figure
18) is as follows:
Table 17. Node Display and Indication (Screen 2)
Display Indication
Rate Update rate of Limitless™ switch or sensor
R_Lo Low output value of a Limitless™ sensor
R_Hi High output value of a Limitless™ sensor
S/N Serial number of Limitless™ switch or sensor
N/A Information not available
Not Read Yet Information available*
*Information needs to be read from Node: Operator will need to
scroll to “Prev” or “Next” screen and then back to this screen to
allow updating of information. This action may need to be repeat-
ed to allow time for information to be displayed.