User's Manual
Honeywell Sensing and Productivity Solutions 21
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE 1
32309669
The PURGE MODE (see Figure 29) can be accessed by touching
the “PURGE” function button as displayed in the Conguration
Menu (see Figure 21). Once you are in the PURGE MODE you can
choose ALL or any of the 14 node numbers to purge by scrolling
“Up” or “Down” to the desired Node number and then touching
“Start”.
The screen will display the following; Figure 30:
Figure 30. Purge Mode - Purge Update Sent
After successful purging the screen will display the following; Figures
31 & 32:
Figure 31. Purge Mode - Single Node Being Purged
Figure 32. Purge Mode - Multiple Nodes Being Purged.
Example #2 and #5 Nodes Being Purged
You must touch the “HOME” function button to return to the CON-
FIGURATION MENU.
6.10 | Node Update Rate Mode
Figure 33. Node Update Rate Mode
The NODE UPDATE RATE MODE (see Figure 33) can be accessed
by touching the “NODE UPDATE RATE” function button as dis-
played in the Conguration Menu (see Figure 21). Once you are in
the NODE UPDATE RATE MODE you can choose any of the 14
node numbers to update by scrolling “Up” or “Down” to the desired
Node number and then touching “Enter”.
The screen will display the following; Figure 34:
Figure 34. Node Update Rate - Update Rate in Process
The screen will then change to show the current Update Rate that
is being used in the Limitless™ switch or analog sensor (see Figure
35). The update rate options for the different Series are as follows:
WPS Series: 0.1s, 0.25s, 0.5s, 1s, 5s, 10s, 30s, or 90s
WBX Series: 1s, 5s, 10s, 30s, or 90s
You can then scroll “Up” or “Down” to the desired Node Update
Rate and touch “Start” to initiate the change in Rate which will lead
to the display in Figure 36 momentarily before returning to the previ-
ous screen display with the updated Rate; Figure 35: