User's Manual
22 sensing.honeywell.com
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE 1
32309669
Figure 35. Node Update Rate - Update Rate Displayed
Figure 36. Node Update Rate - Changed Update Rate
In-Process
Note: If the particular Node # that you are trying to update does not
have update rate capability, the screen will display “Node Rate N/A”.
6.11 | Node LCD Display Mode
Figure 37. Node LCD Display Mode
The NODE LCD DISPLAY TIME Mode (see Figure 37) can be ac-
cessed by touching the “NODE LCD DISPLAY” function button as
displayed in the Conguration Menu (see Figure 21). Once you are
in the NODE LCD TIME Mode you can choose any of the 14 node
numbers to update by scrolling “Up” or “Down” to the desired Node
number and then touching “Enter”.
The screen will display the following (see Figure 38):
Figure 38. Node LCD Time - Update of Time In-Process
The screen will then change to show the current LCD Time that is
being used in the Limitless™ analog sensor (see Figure 39). The
LCD Time options are as follows:
WPS Series: 0%; 99%; 60s, Off 60s; 30s, Off 30s; 15s, Off 15s;
10s, Off 10s; 5s, Off 5s
You can then scroll “Up” or “Down” to the desired LCD Time and
touch “Start” to initiate the change in LCD Time which will lead to
the display in Figure 40 momentarily before returning to the previous
screen display with the updated LCD Time; Figure 39:
Figure 39. Node LCD Time - LCD Time Displayed (i.e.,
0%)