User's Manual

24 sensing.honeywell.com
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE 1
32309669
7 | ANTENNA, CABLE, & MOUNTING
OPTIONS
7.1 | Approved Antenna Options
This section defines the antenna options that can be used in a
particular country of interest; reference Section 2.1 for a list of
Countries per Country Use Code. It is important to determine the
country the WMPR will be used in. Thereby, noting the correct
Country Use Code in the WMPR nomenclature will help ensure
proper selection of antenna and/or cable options. The direct
antenna mounts directly to the WMPR RP-SMA jack while the
remote antenna mounts to the WMPR RP-SMA jack via a cable
assembly (see Section 8.5.1). Further technical information on
the WAN Series antennas, WAMM Series magnetic mounts and
WCA Series cable assemblies can be found in Section 8.5.3.
, ATTENTION
The antenna cables should not be modified (i.e. cut short
and/or re-terminated) as it may affect communication agency
approval.
m WARNING
The WMPR must be installed in accordance with the
requirements specified in this document in order to comply with
the specific Country Communication Agency requirements.
(i.e. FCC, IC, ETSI, ACMA, etc.) See Section 3 as it requires
choosing the correct Country Use Code and thus allowable
antenna and/or cable usage.
, CAUTION
Power to the WMPR should not be applied during installation
of an antenna as damage could occur to the WMPR
electronics.
Table 22. Country Code Use “A” Antenna/Cable/Mounting Options
ANTENNAS FOR USE IN COUNTRY CODE A
(Note: all columns are independent of each other)
Antenna Type
Code (antenna pro-
vided with product)
Direct-Mount
Antennas (allowed
for use)
Remote Mount
Antennas (al-
lowed for use)
Magnetic Remote
Mount Assemblies/
Antennas
WAMM100RSP-005
WAMM100RSP-010
(allowed for use)
Extension Cable As-
semblies/Antennas
for Remote Mount
WCA200RSJRSP-002
WCA200RSJRSP-005
WCA200RSJRSP-010
WCA200RSJRSP-015
WCA200RSJRSP-020
(allowed for use)
Extension Cable As-
semblies/Antennas
for Remote Mount
WCA200RNPRSP-002
WCA200RNPRSP-010
(allowed for use)
00 WAN01RSP WAN03RSP WAN01RSP WAN01RSP WAN06RNJ
02 WAN02RSP WAN06RNJ WAN02RSP WAN02RSP
WAN04RSP WAN09RSP WAN04RSP WAN03RSP
WAN05RSP WAN10RSP WAN05RSP WAN04RSP
WAN11RSP WAN05RSP
WAN09RSP
WAN10RSP
WAN11RSP
Note:
Direct mount: Antennas have an RP-SMA plug that connects directly to the WMPR RP-SMA jack
Remote mount: Remote mount antenna uses a cable with a RP-SMA plug that connects directly to the WMPR RP-SMA jack