User's Guide

36
www.honeywell.com
3 FDAP INSTALLATION
3.13 Power on and startup for FDAP Gen3
The FDAP Gen3 has status LED’s to indicate the various stages of operation.
Figure 9.1: LED indicators
The following table identifies the LED’s and describes the operating conditions of the unit when the LED’s are
turned ON.
Table 3.1: LED indicators
LED
Description
Power LED (Red)
Indicates that the power is supplied to FDAP Gen3. When the FDAP Gen3 is
powered ON, Power LED turns ON automatically.
Ethernet Active LED (Green)
Indicates that FDAP Gen3 is connected to FDN network . When the FDAP
Gen3 is connected to FDN Network, Ethernet Active LED turns ON
automatically.
Ethernet Link LED (Green)
Indicates the Ethernet link activity.
• The LED is steady when there is a valid Ethernet link but no data activity.
• The LED blinks when there is data activity on the Ethernet link.
Status LED/Heart Beat LED (Green)
Indicates the software status of FDAP Gen3 factory image. The Status LED blinks
ON/OFF once every second to indicate that the FDAP Gen3 factory firmware is in
the working condition.