User's Manual
Table Of Contents
- Dolphin® 6100 Mobile Computer User's Guide
- Agency Approvals
- Getting Started
- Terminal Hardware Overview
- Standard Terminal Configurations
- Front Panel Features
- Display Backlight
- Keyboard Backlight
- Using Screen Protectors
- Back Panel Features
- Left Side Panel Features
- Right Side Panel Features
- Top Panel Features
- Bottom Panel Features
- Dolphin Peripherals/Accessories for the 6100
- Dolphin USB Communication Cable
- Battery Power
- Resetting the Terminal
- Suspend Mode
- Changing the Memory Allocation
- Care and Cleaning of the Dolphin Terminal
- Using the Keyboard
- Using the Image Engine
- Communication
- Bluetooth Manager
- Dolphin HomeBase/eBase Device
- Dolphin QuadCharger Device
- Customer Support
3 - 4
Removing the Screen Protector
6100s ship with a touch screen protector already installed. To replace the screen protector, you must
remove the one already installed.
1. Press the Power key to put the terminal in suspend mode.
2. Using a strong, flat, plastic card (e.g., credit card) wedge the edge of the card under the existing
screen protector. Catch the edge of the screen protector and pull it up and away from the touch
panel.
Note: If you have one, you can also use the small plastic squeegees designed for touch panels.
3. Wipe the screen with a clean, non-abrasive, lint-free cloth.
Note: Use ionized air, if available, to blow additional dirt or particles off the touch panel.
Installing Your Screen Protector
When installing a new screen protector, use a flat plastic card (e.g., credit card) to apply the screen
protector smoothly and remove any air bubbles.
Note: If you have one, you can also use the small plastic squeegees designed for touch panels.
1. Press the Power key to put the terminal in suspend mode.
2. Clean the touch panel thoroughly with a clean, non-abrasive, lint-free cloth. Make sure nothing is on
the touch panel.
3. Release the left edge of the backing paper on the screen protector.