User's Manual
Table Of Contents
- Dolphin™ 6110 Mobile Computer User's Guide
- Agency Approvals
- Getting Started
- Hardware Overview
- Standard Terminal Configurations
- Dolphin Peripherals/Accessories for the Dolphin 6110
- USB Communication Cable for the Dolphin 6110
- Front Panel Features
- Using the Touch Panel
- Back Panel Features
- Left Side Panel Features
- Right Side Panel Features
- Top Panel Features
- Bottom Panel Features
- Battery Power
- Hardware Maintenance
- Dolphin 6110 Technical Specifications
- Using the Keypad
- Using the Image Engine
- Using the Laser Engine
- System Settings
- Communication
- Working with the Bluetooth Radio
- Dolphin HomeBase (Model 6100-HB)/eBase (Model 6100-EHB) Device
- Dolphin 6110 Net Base Device (Model 6100-NB)
- Dolphin QuadCharger Device
- Customer Support
2 - 1
2
Getting Started
Out of the Box
Verify that your carton contains the following items:
• Dolphin 6110 mobile computer (the terminal)
• Battery pack (3.7v, Li-Ion)
• AC power supply
(KSAS0100500200D5; Input: 100-240V AC, 50/60Hz 0.4 Amps; Output: 5 Volts DC, 2.0 A)
• Localized plug adapters
Note: Be sure to keep the original packaging in case you need to return the Dolphin terminal for service; see
Customer Support on page 13-1.
Initial Setup for Dolphin 6110 Terminals
Step 1. Install the Battery
The Dolphin 6110 is shipped with the battery packaged separate from the unit. Follow the steps below to
install the battery.
1. Release the strap making it convenient to reach the cover.
2. Remove the battery compartment cover by turning the cover locks upward and removing the cover.
3. Insert the battery into the battery well with the labels facing upward.
4. Replace the cover with a hinging motion and turn the locks downwards.
Note: The battery door must be installed prior to booting the unit.
5. Replace the hand strap.
Cover Locks
Battery
Preliminary 2013-09-16