User's Manual
Table Of Contents
- Dolphin® 7600II Mobile Computer
- Agency Approvals
- Label Locations
- Approvals by Country
- R&TTE Compliance Statement-802.11b/g, Bluetooth, and/or GSM
- Dolphin RF Terminal-802.11b/g, Bluetooth, and/or GSM
- For European Community Users
- Waste Electrical and Electronic Equipment Information
- Pacemakers, Hearing Aids and Other Electrically Powered Devices
- Microwaves
- Getting Started
- Terminal Hardware Overview
- Using the Keyboards
- Using the Image Engine
- System Settings
- Connecting the Terminal
- Working with GSM
- Working with the Bluetooth Radio
- Dolphin HomeBase Device
- Dolphin QuadCharger Device
- Dolphin Mobile Mount
- Technical Specifications
- Customer Support
- Agency Approvals
Dolphin® 7600II Mobile Computer User’s
Guide–Preliminary
Rev (a) 01
5/29/08
10 - 5
Mounting the Dolphin HomeBase Device
If you want to mount the HomeBase to a vertical surface, be sure to provide enough workspace with good
lighting for the user to view and operate the Dolphin terminal while it is seated in the HomeBase.
Back Panel Dimensions
Mounting Guidelines
1. Before you begin, make sure you have two screws that are size #4–diameter measurement of 0.112
in. (2.845 mm).
2. Drill two holes into the wall. The holes should be located approximately 1.44 in. (36.7 mm) apart.
3. Insert a screw into each hole, leaving 0.2 in. (5 mm) of its head exposed.
.15 in.
(3.85 mm.)
1.44 in.
(36.7 mm.)
3.99 in.
(101.42 mm.)
1.85 in.
(46.87 mm.)
4.35 in.
(110.47 mm.)
.32 in.
8.06mm Diameter,
2 places
.53 in.
13.65mm,
2 places