User's Manual
Table Of Contents
- Dolphin® 7600II Mobile Computer
- Agency Approvals
- Label Locations
- Approvals by Country
- R&TTE Compliance Statement-802.11b/g, Bluetooth, and/or GSM
- Dolphin RF Terminal-802.11b/g, Bluetooth, and/or GSM
- For European Community Users
- Waste Electrical and Electronic Equipment Information
- Pacemakers, Hearing Aids and Other Electrically Powered Devices
- Microwaves
- Getting Started
- Terminal Hardware Overview
- Using the Keyboards
- Using the Image Engine
- System Settings
- Connecting the Terminal
- Working with GSM
- Working with the Bluetooth Radio
- Dolphin HomeBase Device
- Dolphin QuadCharger Device
- Dolphin Mobile Mount
- Technical Specifications
- Customer Support
- Agency Approvals
3 - 14 Rev (a) 01
5/29/08
Dolphin® 7600II Mobile Computer User’s
Guide–Preliminary
Installing Memory Cards
This terminal supports microSD and microSDHC memory cards up to 4GB.
To install an SD card, you must open the access door on the side panel (Side Panel Features, page 3-
12). Access door removal requires a Torx 5 (T5).
1. Press the Blue + Backlight keys to put the terminal in Suspend Mode (see page 3-26).
2. Place the terminal on a flat, secure surface with the keyboard face-down.
3. Use a T5 screwdriver to remove the screw on the micro-SD door.
4. Remove the access door.
5. Slide the micro-SD card in with the contacts facing up (away from the keyboard) and the flat, straight
edge parallel to the top panel (with the imager).
Note: To remove an installed SD card while the access door is open, tap on the edge lightly to unlock
the card; the card will pop out just enough for you to grab its edge and pull it out.