User's Manual
Table Of Contents
- Dolphin® 7600II Mobile Computer
- Agency Approvals
- Label Locations
- Approvals by Country
- R&TTE Compliance Statement-802.11b/g, Bluetooth, and/or GSM
- Dolphin RF Terminal-802.11b/g, Bluetooth, and/or GSM
- For European Community Users
- Waste Electrical and Electronic Equipment Information
- Pacemakers, Hearing Aids and Other Electrically Powered Devices
- Microwaves
- Getting Started
- Terminal Hardware Overview
- Using the Keyboards
- Using the Image Engine
- System Settings
- Connecting the Terminal
- Working with GSM
- Working with the Bluetooth Radio
- Dolphin HomeBase Device
- Dolphin QuadCharger Device
- Dolphin Mobile Mount
- Technical Specifications
- Customer Support
- Agency Approvals
Dolphin® 7600II Mobile Computer User’s
Guide–Preliminary
Rev (a) 01
5/29/08
7 - 3
5. When the IrDA port finds the IrDA port of the other device, it immediately starts sending the selected
file. The selected device reads “Sending.”
6. When the file transfer is complete, the selected device reads “Done.”
Receiving Data
The Beam Setting must be set to receive for the terminal to receive data from other infrared devices.
1. Verify that beam settings are set to receive. Tap Start > Settings > Connections tab > Beam. The
Beam Settings window should appear as follows:
2. Align the IrDA ports.
3. Have the owner of the other device send the information to you.
4. Your terminal automatically begins receiving it.
5. A popup message appears asking if you want to receive the incoming file.
6. Tap Yes to receive the file.