User's Manual
Table Of Contents
- Dolphin® 7600II Mobile Computer
- Agency Approvals
- Label Locations
- Approvals by Country
- R&TTE Compliance Statement-802.11b/g, Bluetooth, and/or GSM
- Dolphin RF Terminal-802.11b/g, Bluetooth, and/or GSM
- For European Community Users
- Waste Electrical and Electronic Equipment Information
- Pacemakers, Hearing Aids and Other Electrically Powered Devices
- Microwaves
- Getting Started
- Terminal Hardware Overview
- Using the Keyboards
- Using the Image Engine
- System Settings
- Connecting the Terminal
- Working with GSM
- Working with the Bluetooth Radio
- Dolphin HomeBase Device
- Dolphin QuadCharger Device
- Dolphin Mobile Mount
- Technical Specifications
- Customer Support
- Agency Approvals
11 - 6 Rev (a) 01
5/29/08
Dolphin® 7600II Mobile Computer User’s
Guide–Preliminary
Troubleshooting
If you encounter problems with the QuadCharger device, refer to chart below for possible solutions. If
problems persist, please contact Technical Assistance (see page 14-2).
Problem Issue
The Status LED does not come on
when I insert a battery pack into a
slot.
Check the power connections on the QuadCharger device; make
sure the POWER switch is ON and the battery pack is properly
seated.
The Status LED lights red during
charging.
Try to charge the battery in one of the other charging slots. If the
red Status LED comes on again, then the problem is associated
with the battery pack. If the red status stays with the charging slot,
the problem is associated with the charging circuitry.
The Status LED lights red and stays
on without a battery in the charging
slot.
An error occurred during the self-diagnostic test for that particular
charging pocket. Call Honeywell Product Service and Repair (see
page 14-1) to request an RMA.