User's Guide Part 15

5
GREEN LED: NORMALLY OFF ONE SHORT FLASH - RF MESSAGE DECODED ONE LONGER FLASH - COMMAND RECEIVED FROM CONTROL NOTES: WHEN AN ENCRYPTED TRANSMITTER IS SUCCESSFULLY ENROLLED, LED FLASHES A NUMBER OF TIMES THAT IS EQUAL TO THE SPACE AVAILABLE FOR ADDITIONAL ENCRYPTED KEYS. THE GREEN LED IS ALSO USED WHEN CHECKING ENCRYPTED KEY SPACE AVAILABLE AND PERFORMING DELETIONS. SEE ENCRYPTED KEYS DESCRIPTION FOR DETAILS.
NOTE: WHEN CIRCUIT BOARD IS MOUNTED IN CONTROL'S CABINET, GROUNDING LUGS (2) PROVIDED
MUST
BE INSERTED IN LEFT-
HAND TERMINALS OF ANTENNA BLOCKS AND SECURED TO CABINET (SEE RECEIVER'S AND CONTROL'S INSTRUCTIONS). WHEN BOARD IS MOUNTED IN A SEPARATE CABINET (COMMERCIAL FIRE APPLICATION), DO NOT USE THE GROUNDING LUGS. TO RELEASE CIRCUIT BOARD, BEND BACK BOTTOM TABS (2). FOR COMMERCIAL FIRE APPLICATION. USE TWO SCREWS (NOT SUPPLIED) WITH INSULATING WASHERS BENEATH THE HEADS. TO MOUNT BOARD IN SEPARATE CABINET. (SEE RECEIVER'S INSTRUCTIONS).
MOUNTING
HOLES
CIRCUIT
BOARD
INTERFERENCE
INDICATOR LED
PLUG & SOCKET
WIRING OPENING
YELLOW RED BLACK GREEN
FCC ID CFS8DL5882AP
.
USE MAX. OF 220 ft. (67m) OF #22 (0.64mm) WIRE OR 550 ft. (168m) OF #18 (1mm) WIRE FOR EACH RUN. 20 ft. MAX. IN COMMERCIAL FIRE INSTALLATIONS. (SEE RECEIVER'S INSTRUCTIONS).
TO CONTROL'S KEYPAD TERMINALS. EACH RECEIVER MUST BE ON INDIVIDUAL HOME RUN.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
DIP SWITCH #5 ON: FOR USE IN COMMERCIAL FIRE APPLICATIONS.
(SEE THE RECEIVER'S INSTRUCTIONS).
OFF: USE IN NON-COMMERCIAL FIRE INSTALLATIONS.
SWITCH RECEIVER ADDRESS SETTINGS
POSITION (“—” means “OFF”)
01234567
5 (SEE TEXT ABOVE)
4 — ON — ON — ON — ON
3 ——ON ON ——ON ON
2 ————ON ON ON ON
1
5 4 3 2 1
ON
OFF
MUST BE IN OFF POSITION
DETAIL A
FRONT AND
REAR TAMPER
5881ENHC ONLY
SEE DETAIL A
5881EN SERIES
5881ENL
5881ENM
5881ENHC
5881ENH
DIP SWITCH: WHITE AREAS = SWITCH HANDLES POSITION 2-4: DETERMINE RECEIVER'S ADDRESS CONSULT CONTROL'S INSTRUCTIONS FOR ADDRESS TO USE. DIP SWITCH BELOW SHOWN SET FOR ADDRESS "0".
BACK OF PC BOARD
FRONT OF PC BOARD
ANTENNAS
INSERT IN
RIGHT-HAND
TERMINALS
DIP SWITCH
5881EN-SOC-V1
Figure 3: Summary of Connections, 5881EN Series RF Receivers