User's Guide Part 15

PREK4460-1V5 8/05 Rev A
ADEMCO 6150RF
ADEMCO 6150RFADEMCO 6150RF
ADEMCO 6150RF
Keypad/Transceiver
Keypad/TransceiverKeypad/Transceiver
Keypad/Transceiver
INSTALLATION AND SETUP GUIDE
GENERAL INFORMATION
The 6150RF Keypad/Transceiver is a combination unit incorp-
orating a normally-open relay output and the functions of:
• 6150 Fixed Addressable Keypad
• 5881M RF Receiver
• 5800TM Transmitter Module
The 6150RF Keypad/Transceiver may be used on any control
panel that supports the 6150 Keypad (e.g., VISTA-10P/10SE,
VISTA-15/15P, VISTA-20P/20SE/20HWSE, VISTA-40, VISTA-
50P, VISTA-128B/128BP, 4110DL, 4110XM, 4140XMP)
Wireless Features
The 6150RF supports the following:
• 5828/5828V wireless keypads.
• Up to 8 wireless keys locally (programmed directly into
6150RF) without occupying any zones supported by the
control panel.
• Button-type transmitters (e.g., 5804, 5804BD) for local
operation.
• A maximum of 16 transmitters programmed into any 5800
Series-supported control panel.
• Wireless keys with high-security (e.g., 5804E).
• RF jam detection when the receiver is enabled.
The 6150 provides the following:
• Low-battery indications for the local wireless keys.
• A nominal range of 200' for the RF transmitters (some
transmitters have a shorter range).
• Wireless key support for control panels that do not support
RF themselves (such as 4110DL).
U
UU
U
L
LL
L
The 5802, 5802MN, 5802MN2, 5804, 5804BD, 5804BDV, 5804E,
5804WATCH, 5805BDV, 5814, 5816TEMP, 5819, 5819SBRS,
5819SWHS, and 5850 transmitters are not intended for UL
installations.
Programming Features
• Auto Enroll mode for programming wireless keys.
• Provides a method for deleting a serial number and re-
enrolling a new one in its place.
• Provides default settings for the wireless key functions.
Additional Features
• Sends status signals (Armed, Ready, etc.) to bi-directional
units such as 5804BDV, 5805BDV and 5828/5828V.
• Operates the on-board relay in conjunction with the receiver
(e.g., to trip a garage door opener).
Note: This particular feature is not intended for UL installations.
• Activates relays programmed into the control panel.
• Provides an End User mode to enable/disable local wireless
keys (e.g., if a user accidentally loses a wireless key). (Refer
to the 6150RF User Guide for this procedure.)
APPLICATION GUIDELINES
Use the following guidelines when planning an installation:
• Local wireless keys (wireless keys programmed directly into
the 6150RF) may be used regardless of whether the RF
receiver in the 6150RF is enabled or disabled.
• If using bi-directional devices, be sure to enable the
transmitter module in the 6150RF.
• If transmitters are programmed into the control panel, be
sure to enable the receiver. (Make sure you do not exceed
the number of receivers supported by the control panel.)
• If a local wireless key is programmed to arm/disarm or to
trigger a relay on the control panel, a user code must be
entered into the 6150RF. This user code must also be
programmed into the control panel.
• You must set the House ID only if you are using RF keypads
and/or bi-directional devices; AND the House ID Source is
the 6150RF (Local).
6150RF Application Guide
The following guide outlines how to program the wireless keys, RF receiver, and the House ID in the 6150RF for your installation.
* Two 6150RFs are needed for this application: one assigned to partition 1 and one assigned to partition 2.
** If using an RF keypad on only one partition, the 6150RF’s partition assignment must match the partition set in field 1*48.
*** If set for Local on a partition control, the 6150RF’s partition assignment must match the one programmed in the BD device.
Are you using
6150RF Programming Options
System Control Panel
RF keys
beyond
system’s
capacity?
RF receivers
beyond
system’s
capacity?
RF keypads and/or Bi-
directional devices on
more than 1 partition?
Program
Wireless Keys
Into
Receiver
Enable
House ID
Source***
4110DL, 4110XM, 4140XMP, VISTA-
20HWSE
N/A N/A N/A 6150RF OFF Local [0]
NO NO N/A System ON [1] System [1]
YES NO N/A 6150RF ON [1] System [1]
VISTA-10P, VISTA-10SE, VISTA-15,
VISTA-15P, VIA-30PSE
YES YES N/A 6150RF OFF [0] Local [0]
NO NO NO System ON [1] System [1]
YES NO NO 6150RF ON [1] System [1]
YES YES NO 6150RF OFF [0] Local [0]
NO YES YES* System OFF [0] Local [0]
VISTA-20SE, VISTA-20P
YES YES YES* 6150RF OFF [0] Local [0]
NO NO NO** System ON [1] System [1]
YES NO NO** 6150RF ON [1] System [1]
YES YES NO** 6150RF OFF [0] Local [0]
NO YES YES System OFF [0] Local [0]
VISTA-40, VISTA-50P, VISTA-128B,
VISTA-128BP
YES YES YES 6150RF OFF [0] Local [0]
SEE THE NEXT PAGE
FOR THE FCC INFO.