User's Manual

Installation and Setup Guide
Ref: LKP500-EN
FEATURES & NOTES
• Wireless alpha keypad serves as a secondary keypad for controlling the Lyric
Smart Controller’s security functions.
• Uses SiX™ technology protocol for secure, bidirectional communication.
• Use up to eight (8) keypads with the Lyric Smart Controller.
• Easy enrollment in the Controller.
• Mounts to a wall or desk stand.
• Supervised; supervision time is 60 minutes (cannot be changed).
• Locate the keypad within 300 feet of the Lyric Smart Controller.
• Powered by an external 110VAC input/9VDC output power pack (supplied).
• Battery pack (7.2VDC) provides 24-hour backup power (supplied).
LED Status indicators
Indicator Color OFF BLINKING ON
Security
Shield
Green
System not
ready
AC Loss System ready to arm
Red
System
disarmed
AC Loss
Entry Delay
with AC Loss
Exit Delay
System armed
Panic Red Not active N/A
Active, waiting for selection of
panic alarm type
INSTALL THE BATTERY AND CONNECT THE POWER SUPPLY
IMPORTANT:
DO NOT connect the power
supply to an AC outlet yet. See
“Enroll the Keypad.”
MOUNT THE KEYPAD
ENROLL THE KEYPAD
The keypad must be enrolled in the Lyric Smart Controller before it can be used.
1.
At the Smart Controller, enter Programming
mode and follow the control’s instructions to
enter keypad enrollment mode
(Program > RF Keypad > Add New > Serial Number).
• RF keypads are assigned zone numbers, starting
with zone 850. Selecting “Add New” automatically
assigns the next available RF keypad zone numb
er.
2.
While the Controller is in enrollment mode, plug the
keypad’s power pack into a 24hr, non-switchable outlet.
• The keypad automatically attempts to pair with the
Controller.
• If enrollment is not successful, press any key on the
keypad to restart the pairing process or disconnect and
reconnect power.
3.
After successful pairing, k
eypad
displays Disarmed, Ready.
• When enrolled, the keypad’s ID
number appears on the
Controller’s Programming
screen.
4. After enrollment, program and save the keypad’s zone options (zone descriptor, etc.) at the Smart Controller.
IMPORTANT: Once enrolled, the keypad cannot be used with another control panel until it is un-enrolled from the current
controller. See the Smart Controller’s Programming Guide for details on removing devices.
BATTERY REPLACEMENT
IMPORTANT: Unplug the keypad power supply BEFORE starting.
Reconnect power after the keypad is re-mounted.
SPECIFICATIONS
Physical:
6.7
”
W x 5.4
”
H x 0.9
”
D (170mm x 136mm x 22mm)
Frequency: 2.4 GHz
Battery Pack:
Part number 300-06868: 7.2V, 6xAAA, 6x600mAH, NiMH
Transformer:
Part number 300-07332US: 110VAC input/9VDC, output
1A, 2-prong
LCD Display: 2x16
Sounder:
Speaker/Codec
Notes on Keypad Supervision
• When a trouble condition is detected, the keypad displays a trouble
message and begins to beep.
• Press any key to stop the beeping.
• Keypad supervision time is set at 60 minutes (cannot be changed).