User's Manual

Lyric-
CDMA
Installation Instructions
Lyric-CDMA Communication Module Installation Guide
For Documentation and Online Support: http://www.security.honeywell.com/hsc/resources/MyWebTech
General Information
The Lyric-CDMA Communication Module allows the Lyric Smart Controller to communicate with the Central Station via the
cellular radio network.
NOTE: Before installing the communication module, remove power from the control or use the “Install Cell” mode
described in the Replacing the Module section below.
Installing the Lyric-CDMA Module
1. Install the provided FCC/IC label (P/N 800-19688) on
the control’s case back.
2. Remove bezel from right-hand side of control to
expose the radio module slot To remove bezel, push
upward.
3. Insert the module into the slot. Push firmly to mate the
edge connector.
4. Replace the bezel.
5. Use AlarmNet Direct to enable the Lyric-CDMA
module, configure alarm reporting and module
supervision, and register the module.
Typical FCC/IC Label Location
Removing the Bezel
Installing the Lyric-CDMA Module
Replacing the Module
In the event the module needs to be replaced, the Control must first be put in module replacement (“Install Cell”) mode to
avoid causing a tamper alarm.
1. Select the Install Cell button.
(
Security – More – Tools – enter code – Test – Install Cell)
This mode deactivates tamper protection so the side
bezel can be removed without causing an alarm.
2. Remove the side bezel. See diagram above.
3. Remove the screw that secures the module to the
control.
4. Remove the communication module from its
connection slot.
5. Insert the new module into the slot. Push firmly to
mate the edge connector. Replace the securing screw.
6. Replace the bezel.
7. Use AlarmNet Direct to enable the Lyric-CDMA
module, configure alarm reporting and module
supervision, and register the module.
HONEYWELL
PRELIMINARY
PLEASE GO TO BOTTOM OF
THE NEXT PAGE FOR FCC / IC
AGENCY STATEMENTS.