User Manual Part 3

5 - 12 Dolphin® 9500/9550 Mobile Computer User’s Guide
Status Icon
You can access the configuration utility by tapping and holding on the Status icon at any time. The following menu displays:
The four menu entries at the bottom correspond to the four configuration settings tabs: the Status, Config, Advanced, and About
respectively. This side menu provides a shortcut to the configuration settings.
Wireless Radio On Turns on the radio. LED is on and the Link Icon displays with signal strength.
Wireless Radio Off Turns off the radio. A pop-up window will ask for your confirmation. If confirmed, the LED will be off
and the Link Icon will change color from green to red on the top without signal strength displayed. The
WLAN card/module will stop functioning.
Remove Status Icon Removes the Status Icon from the Windows Status Tray. A pop-up window will ask for your
confirmation. If confirmed, the Status (Link) Icon will be removed from the Windows Status Tray.
Wireless Network Status Opens the Status tab of the configuration utility
If the Status Icon changes to a crossed lock , it warns you that you may have entered a wrong key (WEP Key mismatch) for
the WEP-On AP or a station.
Note: You can also go to Start > Programs > HHP WLAN Settings.
Remove Wireless Status Icon Window
If you choose to remove the Remove Status Icon, the screen shown below displays:
Press Yes to confirm, or No to cancel.
If confirmed, the Status Icon will not display in the Windows Status Tray. By checking “Remove Status Icon Permanently” at the
bottom of the window you will not see the Status Icon even after your system has been restarted. Otherwise it will re-appear next
time you turn on the system.