User's Manual

12 - 5
Mounting
The adjustable mounting bracket holds the terminal securely in place and gives the user a variety of
options for mounting the base. When selecting a location, keep in mind that the power supply and serial
connectors point straight out the bottom panel.
1. Loosen the turnscrew.
2. Insert the ball joint of the mounting bracket to the back of the bracket.
3. Insert the ball joint on the back of the base into the other side of the bracket.
4. Tighten the turnscrew to secure both ball joints.
5. Secure the mounting bracket to the appropriate location.
Latch
Locking tabs
NEW IMAGE
REQUIRED
Spring Arm Assembly
Ball Joint
Turnscrew
Ball Joint
Power supply and RS232
Bracket
connectors (not in view)
Mounting Bracket
Back Panel
Latch
The latch sits on top of the spring arm assembly and holds the back of the terminal securely in
place. The 9700 version of the base for the pistol-grip option contains a special latch to
accommodate the optional handle.
Locking Tabs
When positioned as shown in the above graphic, the locking tabs secure the spring arm
assembly, latch, and terminal in place. When seating a terminal, turn both arms up to allow the
spring arm to move as necessary while the terminal is being inserted. After the terminal is
seated, turn both arms toward the center to lock them.
Both locking tabs must be pointing up to insert or remove a terminal in the base.