User's Manual
Table Of Contents
- Dolphin® 9900 Mobile Computer
- Disclaimer
- Trademarks
- Patents
- Other Trademarks
- Agency Information
- Label Locations
- Laser Safety Label
- LED Safety Statement
- Infrared LED Safety Statement
- UL and cUL Statement
- Regulatory and Safety Approvals for all Dolphin Terminals
- Dolphin 9900 802.11b/g (WLAN), Bluetooth, and/or GSM
- FCC Compliance
- Canadian Compliance
- For European Community Users
- Pacemakers, Hearing Aids and Other Electrically Powered Devices
- Microwaves
- Getting Started
- Hardware Overview
- Using Scan Image Engine
- Using Dolphin Keyboards
- Settings
- Wireless Communication
- Working with GSM
- Working with Bluetooth
- Dolphin HomeBase
- Dolphin Mobile Base
- Dolphin ChargeBase
- Dolphin QuadCharger
- Customer Support
12 - 4 Rev (a) 02
3/5/08
Dolphin® 9900 Mobile Computer
User’s Guide–Preliminary
Supplying Power to the ChargeBase
Using a non-Hand Held Products power adapter voids your warranty and could result in serious
damage to the circuitry of the Dolphin ChargeBase.
1. Be sure the power switch on the power adapter is in the OFF position.
2. Plug the power cord into the power adapter.
3. Plug the power connector cable into the power connector on the back panel of the ChargeBase.
4. Plug the power cord into a standard wall outlet.
5. On the power adapter, turn the power switch to the ON position. The LEDs illuminate as the
ChargeBase powers up.
6. The ChargeBase is ready to begin charging terminals.
Inserting and Removing Terminals
1. To insert the terminal, hold the terminal with the bottom panel perpendicular to the base.
2. Slide the terminal into the well until the Dock LED lights solid green.
3. Charging begins immediately.
Note: To remove a terminal, grasp it firmly in your hand and lift it up and out of the terminal well. The LEDs for the
terminal well turns off.
!