User's Manual
Table Of Contents
- Dolphin® 9900 Mobile Computer
- Disclaimer
- Trademarks
- Patents
- Other Trademarks
- Agency Information
- Label Locations
- Laser Safety Label
- LED Safety Statement
- Infrared LED Safety Statement
- UL and cUL Statement
- Regulatory and Safety Approvals for all Dolphin Terminals
- Dolphin 9900 802.11b/g (WLAN), Bluetooth, and/or GSM
- FCC Compliance
- Canadian Compliance
- For European Community Users
- Pacemakers, Hearing Aids and Other Electrically Powered Devices
- Microwaves
- Getting Started
- Hardware Overview
- Using Scan Image Engine
- Using Dolphin Keyboards
- Settings
- Wireless Communication
- Working with GSM
- Working with Bluetooth
- Dolphin HomeBase
- Dolphin Mobile Base
- Dolphin ChargeBase
- Dolphin QuadCharger
- Customer Support
Dolphin® 9900 Mobile Computer User’s
Guide–Preliminary
Rev (a) 02
3/5/08
7 - 3
5. When the IrDA port finds the aligned IrDA port, it immediately starts sending the selected file. The
selected device reads “Sending.”
6. When the file transfer is complete, the selected device reads “Done.”
Receiving Data
The Beam Setting must be set to receive for the terminal to receive data from other infrared devices.
1. Verify that beam settings are set to receive. Tap Start > Settings > Connections tab > Beam. The
Beam Settings window should appear as follows:
1. Align the IrDA ports.
2. Have the owner of the other device send the information to you.
3. Your terminal automatically begins receiving it.
4. A popup message appears asking if you want to receive the incoming file.
5. Tap Yes to receive the file.