User's Manual

3 - 17
• after installing some software applications.
• after making changes to certain system settings, such as network cards.
1. Press and hold the CTRL + ENTER keys for approximately 5 seconds.
2. The decode and scan LEDs flash for approximately three seconds as the terminal resets.
3. When the reset is complete, the Home screen displays.
Hard Reset (Cold Boot)
A hard reset re-boots the device and clears RAM data. Files in the user store are not affected unless you
are performing a software upgrade.
A hard reset erases all of the data stored in RAM memory!
1. Press and hold the CTRL + ESC keys for approximately 5 seconds.
2. The decode and scan LEDs light for approximately 3 seconds.
3. The terminal re-initializes; see Initialize the Mobile Computer on page 2-8.
Software/Operating System Upgrades
Software upgrades reset the device back to a factory state. Back up all user files to a storage card or
external memory prior to performing a software upgrade. All files in the user store will be erased during
an operating system upgrade. Data stored in the IPSM directory is preserved during an operating sys-
tem upgrade.
Suspend Mode
The terminal goes into Suspend Mode automatically when the terminal is inactive for a programmed
period of time. You can program this time on the Advance tab of the Power System Setting; see Power
on page 7-16.
To put the terminal into Suspend Mode manually, press the Power key and the screen goes blank.
To wake the terminal from Suspend Mode, press the Power key or SCAN key .
Hardware Maintenance
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free
cloth. The terminal can be cleaned with a damp cloth.
For additional information on hardware maintenance specific to the Dolphin Healthcare Housings, see
page 3-12.
ALT
CTRL
ENT
!
ALT
CTRL
ESC
SCAN
Preliminary Draft 1/19/11