User's Manual

18 - 2
Parts and Functions
Front and Side Panel
Terminal Wells
The rack contains thirty terminal wells. Place the Dolphin terminal in any one of the thirty wells
to communicate with a host device (Net Base only), power the terminal, and charge the
installed battery pack. The rack completely charges the main battery in a Dolphin terminal in
4.5 hours for the standard 3.7V battery or 6 hours for the extended 3.7 battery.
AC Power Jack
Use the AC power cable from Honeywell that comes with the rack to supply power to this power
jack. For more information, see Power on page 18-2.
RJ45 Ethernet Ports (Net Rack Only)
The Net Rack contains an RJ45 Ethernet port. You can connect the Net Rack to an Ethernet-
compliant device to facilitate Ethernet communication to and from the terminal by plugging a
standard CAT-5 Ethernet cable into the Ethernet port provided.
Back Panel
For details on how to mount the Charge Rack or Net Rack, see Mounting the Rack on page 18-4.
Power
The rack requires 100 - 240 Volts AC, 6 Amps of power to charge the Dolphin terminals. Honeywell rec-
ommends that you leave the rack connected to its power source at all times, so that it is always ready to
use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
30 Terminal Wells
AC Power Jack
RJ45 Ethernet Port
(Net Rack Only)
!
Preliminary Draft 1/19/11