User's Manual

©2010 Honeywell International Inc. All rights reserved. ACC-PT-QS Rev (a) 4/10
Preliminary Draft 4/28/10
Access Point Quick Start
Connecting the Access Point
1. Turn on the computer (laptop/desktop).
2. Plug the interface cable into the Access Point first and then into the appropriate port on the computer. The Page button
lights up when the connection is made.
Managing Connections
Only one scanner may be linked to the Access Point at a time. To link a different scanner to the Access Point, use the new scan-
ner to scan the Linking bar code on the Access Point. That unlinks the first scanner and links the second one.
Connection Range
The scanner is in communication with the Access Point even if it is not transmitting bar code data. If you take the linked
scanner out of range of the Access Point, communication with the module will be lost and you will have to reconnect the
scanner to the Access Point. To reconnect the scanner, scan the Linking bar code.
Changing Batteries
If the scanner turns off due to a low battery, you can change the battery without losing the link with the Access Point, pro-
vided the scanner is in range. A few seconds after the scanner powers up, the scanner relinks to the module. Refer to your
User’s Guide at www.honeywellaidc.com for additional information about charging the batteries.
3. Scan the linking bar code on the top of the Access Point to establish a connection
between the Access Point and the scanner. The scanner emits a short beep and flashes
the green LED to confirm a connection with the Access Point. The Access Point’s Page
button remains blue.
USB Connection:
RS232 Connection:
RS485 Connection:
Keyboard Wedge Connection:
Page button