User's Manual

3. Remove any of the plugs by unscrewing them in a counter-clockwise direction. Remove only the plugs necessary to
mount the hand strap. See the illustration below for possible hand strap orientations:
Horizontal
Vertical
Diagonal
4. Insert the Strap Attaching Screws into the appropriate holes. These screws have an eye to attach the strap.
5. Thread the nylon loop of the Strap Buckle through one of the Strap Attaching Screws from the outside edge of the
Marathon. Then thread the buckle end of the strap through the loop and pull tight.
6. The hand strap kit contains two straps. Use the longer strap for a horizontal or diagonal mount and use the shorter strap
for the vertical mount. Thread the nylon loop of the appropriate strap through the other Strap Attaching Screw. Then
thread the strap through the loop and pull tight.
7. Making sure the closed loop fastener surface on the hand strap is facing up, slide the strap through the latch in the top
clip.
8. Fold the end of the strap over so that the closed loop fastener surfaces mate evenly and the hand strap is secured to the
Marathon.
9. Test the strap's connection making sure the Marathon is securely connected to each end of the strap connectors.
Check the closed loop fastener and hand strap base connection frequently. If loose, they must be tightened or replaced before
the Marathon is placed into service again.
2-10