User's Manual

E-EQ-RX2OGWW-B RX2 User’s Guide
Appendix A Regulatory Notices and Safety Information
FCC Information:
This device complies with FCC Rules, part 15. Operation is subject to the following two conditions:
1. This device may not cause harmful interference
and
2. This device must accept any interference, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction guide, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Warning: Changes or modifications to this device not expressly approved by LXE, Inc., could void the user’s
authority to operate this equipment.
Industry Canada:
This Class A digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouiller du
Canada. Le present appareil numérique n’emet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numeriques de le Classe A préscrites dans le Reglement sur le brouillage radioélectrique édits par le
ministere des Communications du Canada.
RF Safety Notice
Caution
This device is intended to transmit RF energy. For protection against excessive RF exposure to
humans and in accordance with FCC and Industry Canada rules, this transmitter should be
installed such that a minimum separation distance of at least 25cm (9.8 in.) is maintained
between the antenna and the general population. This device is not to be co-located with other
transmitters.
Notice:
The long term characteristics or the possible physiological effects of radio frequency electromagnetic fields have not
been investigated by UL.
Antenna Description:
The antenna approved to operate with the RX2 Vehicle Mount Computer is a Right Hand, Circularly Polarized
(RHCP) single-patch with 5dbi linear gain.
For ENG/CERT Review - Not for Distribution or Publication - Draft 04