User's Manual

EN-72
APPENDIX


 Troubleshooting Guide
Symptom Possible causes Solutions / Corrective Actions
Power does not
turn on.
Camera suddenly
powers down.
Image is not captured
when the shutter
button is pressed.
Flash does not fire.
Continuous shooting
is not possible.
Cannot transfer files
over a USB connection.
* Load new or fully charged battery.
* Load the battery in the correct direction.
* Close the battery cover correctly.
* Properly connect the AC power
adapter.
* Turn the power back on and set the
option of [Auto Off] to [Off].
* Load new or fully charged battery.
* Rotate the mode dial to
, , ,
, or .
* Transfer the desired files to your
computer and then delete unnecessary
files, or use a different memory card.
* Select a different flash mode.
* Select [Std.] in the [Drive Mode].
* Switch the mode dial to another mode.
* Insert a new SD memory card.
* Check all connections.
* Install the USB driver on your computer.
* Turn on the camera.
* The battery has run out.
* The battery is not oriented correctly.
* The battery cover is not closed properly.
* The AC power adapter (optional)
is disconnected.
* The function of [Auto Off] in the
mode
has been activated.
* The battery has run out.
* The camera is in the
mode.
* Memory is full.
* NO FLASH is selected in flash mode.
* The [Drive Mode] is set to [HS Continuous]
or [Auto Bracket].
* The camera is in the
(movie) mode.
* The capacity of the built-in memory or
SD memory card is full.
* USB cable is not connected securely.
* USB driver is not installed.
* Camera is turned off.