10263-03 Fan Manual

Hex Nut
Rubber
Washer
Finial Cap
Finial
14
LIGHT KIT INSTALLATION
23. To install the fan with the light kit:
Remove the three tter plate screws from tter
plate. Then connect the 9-pin connectors from the
motor assembly and the light kit. Ensure the plugs
are connected tightly (Fig. 23).
Fig. 23
Switch
Housing
9-pin
Connector
Fitter Plate
Fitter Plate
Screw
Fig. 24
Fitter Plate
Screw
24. Align holes in the switch housing with holes in the
tter plate. Re-insert the three previously removed
tter plate screws. Use a Phillips screwdriver to
secure all screws (Fig. 24).
Fitter Plate Screw
Fitter Plate Screw
Fig. 25
25. Remove the preassembled rubber washer, hex nut,
nial cap, and nial from the light kit (Fig. 25).