Quick Start Guide
Table Of Contents
- Voyager™ 1202g
- Getting Started
- Power Supply Assembly (if included)
- USB Connection
- RS232 Serial Port Connection
- RS485 Connection
- Keyboard Wedge Connection
- Reading Techniques
- Standard Product Defaults
- RS485 Interface
- Keyboard Country
- Locked Link
- Override Locked Scanner
- Unlinking the Scanner
- Out-of-Stand Modes/CodeGate® Activation
- Reread Delay
- Suffix
- Add Code ID Prefix to all Symbologies
- Data Format Editor Instructions
- 1. Scan the Enter Data Format symbol.
- 2. Primary/Alternate Format: scan 0 for Primary Format
- 3. Terminal Type: scan 099 for any terminal type
- 4. Code I.D.: scan 99 for any bar code type
- 5. Length: scan 9999 for any length bar code.
- 6. Editor commands: use the Programming Chart that follows.
- 7. Scan Save to save your entries.
- Programming Chart
- Changing a Scanner Battery
- EZConfig-Scanning
- Technical Assistance
- Limited Warranty
- User Documentation
- Patents
- Disclaimer
Suffix
If you want a carriage return after the bar code, scan the Add CR
Suffix bar code. To add a tab after the bar code, scan the Add Tab
Suffix bar code. Otherwise, scan the Remove Suffix bar code to
remove the suffixes.
Add Code ID Prefix to all Symbologies
Scan the following bar code if you wish to add a Code ID prefix to all
symbologies at once.
Note: For a complete list of Code IDs, see the User’s Guide for your
product at our website, www.honeywellaidc.com.
Add CR Suffix
Add Tab Suffix
Remove Suffix
Add Code ID Prefix To All Symbologies
(Temporary)