Quick Start Guide
Table Of Contents
- Voyager™ 1202g
- Getting Started
- Power Supply Assembly (if included)
- USB Connection
- RS232 Serial Port Connection
- RS485 Connection
- Keyboard Wedge Connection
- Reading Techniques
- Standard Product Defaults
- RS485 Interface
- Keyboard Country
- Locked Link
- Override Locked Scanner
- Unlinking the Scanner
- Out-of-Stand Modes/CodeGate® Activation
- Reread Delay
- Suffix
- Add Code ID Prefix to all Symbologies
- Data Format Editor Instructions
- 1. Scan the Enter Data Format symbol.
- 2. Primary/Alternate Format: scan 0 for Primary Format
- 3. Terminal Type: scan 099 for any terminal type
- 4. Code I.D.: scan 99 for any bar code type
- 5. Length: scan 9999 for any length bar code.
- 6. Editor commands: use the Programming Chart that follows.
- 7. Scan Save to save your entries.
- Programming Chart
- Changing a Scanner Battery
- EZConfig-Scanning
- Technical Assistance
- Limited Warranty
- User Documentation
- Patents
- Disclaimer
Reading Techniques
Standard Product Defaults
The following bar code resets all standard product default settings.
RS485 Interface
The RS485 interface defaults to port 5B. If you have an IBM POS
terminal using port 9B, scan the appropriate code below to program
the terminal, then power cycle the cash register.
Note: For additional RS485 interface selections, see the User’s
Guide for your product at our website,
www.honeywellaidc.com.
Standard Product Defaults
IBM Port 9B HHBCR-1
Interface
IBM Port 9B HHBCR-2
Interface