Quick Start Guide
Table Of Contents
- Voyager™ 1202g
- Getting Started
- Power Supply Assembly (if included)
- USB Connection
- RS232 Serial Port Connection
- RS485 Connection
- Keyboard Wedge Connection
- Reading Techniques
- Standard Product Defaults
- RS485 Interface
- Keyboard Country
- Locked Link
- Override Locked Scanner
- Unlinking the Scanner
- Out-of-Stand Modes/CodeGate® Activation
- Reread Delay
- Suffix
- Add Code ID Prefix to all Symbologies
- Data Format Editor Instructions
- 1. Scan the Enter Data Format symbol.
- 2. Primary/Alternate Format: scan 0 for Primary Format
- 3. Terminal Type: scan 099 for any terminal type
- 4. Code I.D.: scan 99 for any bar code type
- 5. Length: scan 9999 for any length bar code.
- 6. Editor commands: use the Programming Chart that follows.
- 7. Scan Save to save your entries.
- Programming Chart
- Changing a Scanner Battery
- EZConfig-Scanning
- Technical Assistance
- Limited Warranty
- User Documentation
- Patents
- Disclaimer
Keyboard Country
Scan the Program Keyboard Country bar code below, then scan
the numeric bar code(s) from the end of this document, then the Save
bar code to program the keyboard for your country. As a general
rule, the following characters are not supported by the scanner for
countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~.
Country
Code
Scan
Country
Code
Scan
Country
Code
Scan
Arabia 91 Hungary 19 Spain 10
Belgium 1 IBM Financial 90 Switzerland 6
China 92 Italy 5 Thai 94
Finland 2 Japan 28 Turkey 24
France 3 Korea 93 USA (Default) 0
Germany/
Austria
4 Russia 26 Vietnam 95
Great Britain 7 Slovenia 31
Program Keyboard Country
Save