Install Instructions

THERMOSTAT AND HUMIDISTAT COVER KIT
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9
customer.honeywell.com
® U.S. Registered Trademark
© 2010 Honeywell International Inc.
95-7484—01 E.K. Rev. 03-10
Printed in U.S.A.
Fig. 2. Installation of window insert
4. If a Setpoint Cover Insert is required, assemble per
Figure 3.
Fig. 3. Setpoint cover insert
Table 1. Cover kits
MOUNTING
Mount the cover (Fig. 4) by hooking the two slots on the cover
bottom (right end for horizontal mounting) on the mounting
ears of the backplate. Swing the cover into place. Back out
(counterclockwise) the setscrews with the Thermostat Tool
(CCT735A) or a 0.050-inch Allen wrench to secure the cover.
Fig. 4. Mounting cover
6
0
7
0
8
0
9
0
6
0
7
0
8
0
9
0
WINDOW
(DUAL SHOWN,
PARTIALLY
INSTALLED)
SETSCREW HOLES (4)
(USE HOLES CLOSEST
TO THE WALL)
C7256
M31318
SETPOINT SLOT
SETPOINT
COVER INSERT
Pneumatic Cover Kit Part #’s Description Works with:
14004406-910 Satin Chrome Kit - Fahrenheit TP970, TP971, TP972, TP973 and TP974
14004406-910C Satin Chrome Kit - Celsius TP970, TP971, TP972, TP973 and TP974
14004406-910H Satin Chrome Kit - Humidistat HP970, HP971 and HP972.
14004407-910 Beige Kit - Fahrenheit TP970, TP971, TP972, TP973 and TP974
14004407-910C Beige Kit - Celsius TP970, TP971, TP972, TP973 and TP974
14004787-910 Bright Chrome Kit - Fahrenheit TP970, TP971, TP972, TP973 and TP974
14004878-910 White Kit - Fahrenheit TP970, TP971, TP972, TP973 and TP974
60
70
80
90
60
70
80
90
C8339
By using this Honeywell literature, you agree that Honeywell will have no
liability for any damages arising out of your use or modification to, the
literature. You will defend and indemnify Honeywell, its affiliates and
subsidiaries, from and against any liability, cost, or damages, including
attorneys’ fees, arising out of, or resulting from, any modification to the
literature by you.