Quick Start Guide

Reading Techniques
The view finder projects an aim-
ing dot that should be centered
over the bar code, but it can be
positioned in any direction for a
good read.
Hold the scanner over the bar
code, pull the trigger, and center
the aiming dot on the bar code.
The aiming dot is smaller when
the scanner is closer to the code
and larger when it is farther from the code. Hold the scanner
close to smaller bar codes, and farther away from large bar
codes to get a proper read.
If the bar code is highly reflective (e.g., laminated), you may need
to tilt the scanner at an angle so the bar code can be scanned.
Note: If the scanner razzes when scanning a bar code, the link
has not been established. If the scanner beeps once, the
link has been established.
Standard Product Defaults
The following bar code resets all standard product default set-
tings.
Standard Product
Note: PDF and 2D bar codes can only be read by Voyager model
1472g2D and cannot be read by model 1472g1D.