User's Guide

HH1800 User Guide 199
Replace an Interface Cable
1. Turn off the power to the host system.
2. Disconnect the scanner’s cable from the
terminal or computer.
3. Locate the small hole on the back of the
scanner’s handle. This is the cable
release.
4. Straighten one end of a paper clip.
5. Insert the end of the paper clip into the
small hole and press in. This depresses
the retention tab, releasing the
connector. Pull the connector out while
maintaining pressure on the paper clip,
then remove the paper clip.
6. Replace with the new cable.
Insert the connector into the opening
and press firmly. The connector is keyed
to go in only one way and will click into
place.
Cable Release