User's Guide

HH1800 User Guide 35
* Off
On
Activation Character
This sets the character used to trigger scanning when using Character Activation Mode. On
the ASCII Conversion Chart (Code Page 1252), page 207, find the hex value that represents the
character you want to use to trigger scanning. Scan the following barcode, then use the
Programming Chart to read the alphanumeric combination that represents that ASCII
character. Scan Save to finish. Default = 12 [DC2].
Activation Character
End Character Activation After Good Read
After a barcode is successfully detected and read from the scanner, the illumination can be
programmed either to remain on and scanning, or to turn off. When End Character Activation
After Good Read is enabled, the illumination turns off and stops scanning after a good read. If
you scan Do Not End Character Activation After Good Read, the illumination remains on after
a good read.
Do Not End Character Activation After
Good Read
End Character Activation After Good
Read
Character Activation Timeout
You can set a timeout for the length of time the illumination remains on and attempting to
decode barcodes when using Character Activation Mode. Set the length (in milliseconds) for a
timeout by scanning the following barcode, then setting the timeout (from 1-300,000
milliseconds) by scanning digits from the Programming Chart, beginning on page 211239, then
Save. Default = 30,000 ms.