User's Guide

36 HH1800 User Guide
Character Activation Timeout
Character Deactivation
If you have sent a character from the host to trigger the scanner to begin scanning, you can
also send a deactivation character to stop scanning. Scan the following On barcode to use
character deactivation, then use Deactivation Character (following) to select the character
you will send from the host to terminate scanning. Default = Off.
* Off
On
Deactivation Character
This sets the character used to terminate scanning when using Character Deactivation Mode.
On the ASCII Conversion Chart (Code Page 1252), page 207, find the hex value that represents
the character you want to use to terminate scanning. Scan the following barcode, then use
the Programming Chart, beginning on page 211239 to read the alphanumeric combination
that represents that ASCII character. Scan Save to finish. Default = 14 [DC4].
Deactivation Character
Illumination Lights
If you want the illumination lights on while reading a barcode, scan the Lights On barcode,
below. However, if you want to turn just the lights off, scan the Lights Off barcode. Default =
Lights On.
Note:
This setting does not affect the aimer light. The aiming light can be set using Aimer Mode
(page 47).
* Lights On
Lights Off
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the picture is