User's Guide

HH1800 User Guide 37
taken. Use these codes to set the time between when the trigger is pulled and when the
picture is taken. During the delay time, the aiming light will appear, but the LEDs won’t turn
on until the delay time is over. Default = Off.
1 millisecond
250 milliseconds
500 milliseconds
* Off (no)
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the barcode below, then
set the time-out by scanning digits (0 - 4,000 ms) from the Programming Chart, beginning on
page 211, then Save.
Delay Duration
Aimer Mode
This feature allows you to turn the aimer on and off. Default = On
Off
* On