User's Guide

HH1800 User Guide 61
Note:
99 indicates all symbologies.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable for this
symbology. Scan the four digit data length from the Programming Chart, beginning
on page 211. For example, 50 characters is entered as 0050.
Note:
9999 indicates all lengths.
Step 6. Editor Commands
Refer to Data Format Editor Commands (page 62). Scan the symbols that represent
the command you want to enter.
Step 7. Scan Save to save your data format, or Discard to exit without saving your changes.
Enter Data Format
Save
Discard
Other Programming Selections
• Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary
format, scan 0 from the Programming Chart, beginning on page 211. If you are
clearing an alternate format, scan 1, 2, or 3, depending on the format you are
clearing. Scan the Terminal Type and Code I.D. (see Symbology Charts on page 200),
and the barcode data length for the specific data format that you want to delete. All
other formats remain unaffected.
• Clear all Data Formats
This clears all data formats.
• Save
Exit and save your data format changes.
• Discard
Exit without saving any data format changes.