User Manual

88 Xenon XP User Guide
to an error. To change the number of error beeps, scan the bar code below and then
scan a digit (1-9) bar code from the Programming Chart, beginning on page 309,
then Save. Default = 1.
Good Read Delay
This sets the minimum amount of time before the scanner can read another bar
code. Default = 0 ms (No Delay).
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below,
then set the delay (from 0 - 30,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 309, then Save.
Number of Error Beeps/LED Flashes
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay