User Manual

Xenon XP User Guide 107
1. If you are using bar codes to create your output sequence, scan Enter Output
Sequence on page 110.
2. Code I.D.
On the Symbology Charts on page 295, find the symbology to which you want
to apply the output sequence format. Make a note of the hex value for that
symbology. If you are using bar codes to create your output sequence, scan the
2 digit hex value from the Programming Chart, beginning on page 309.
3. Length
Specify what length (up to 9999 characters) of data output will be acceptable
for this symbology. Make a note of the length. If you are using bar codes to
create your output sequence, scan the 4 digit data length Programming Chart,
beginning on page 309. (Note: 50 characters is entered as 0050. 9999 is a
universal number, indicating all lengths.) When calculating the length, you
must count any programmed prefixes, suffixes, or formatted characters as part
of the length (unless using 9999).
4. Character Match Sequences
On the ASCII Conversion Chart (Code Page 1252), page 298, find the hex value
that represents the character(s) you want to match. Make a note of the hex
value for the character(s). If you are using bar codes to create your output
sequence, use the Programming Chart, beginning on page 309 to read the
alphanumeric combination that represents the ASCII characters. (99 is the
universal number, indicating all characters.)
5. End Output Sequence Editor
Use FF to terminate this string or to begin another output sequence. If you are
using bar codes, scan F F. Scan Save to save your entries.
Other Programming Selections
If you are creating an output sequence using bar codes, scan Discard (page 310)
to exit without saving any output sequence changes.
Output Sequence Editor Commands
SEQBLK Sequence editor start command.
SEQPRE Add prefix to complete output sequences.
SEQSUF Add suffix to complete output sequences.
SEQSEP Add separators to complete output sequences.
SEQTTS1 Transmit partial sequence.
SEQIPR Add prefix to partial output sequences.
SEQISU Add suffix to partial output sequences.
SEQISE Add separators to partial output sequences.