User Manual

Xenon XP User Guide 119
Low Beeper (Daytime Mode)
The following bar code sets all sounds to on, but at a low volume. The scanner
beep, base beep, base and scanner power up beep, and scanner linking sounds are
all set to low volume.
To reset your scanner and base to default sounds, refer to Reset the Custom
Defaults (page 243).
Quiet Operations - LED and Volume Settings
If you have silenced or muted the scanner and base sounds, you may wish to adjust
the visual (LED) indicators for Bluetooth linking sounds, scanning sounds, paging
sounds, and out of range alarm sounds.
Linking LED Colors and Sound
Note: This setting is not supported by the Xenon XP 1950h scanner.
Under normal operations, the scanner chirps when linking to a base or an access
point, and the LED on both the base and scanner flash green. If you want to silence
all sounds and set both devices to flash red LEDs to indicate the linking status,
scan the Red LED Flashes/Silent bar code below. The LEDS flash red while link-
ing, then green to indicate the base and scanner are linked. To return to the default
LED colors and sound, scan Green LED Flashes/Sound. Default = Green LED
Flashes/Sound.
Daytime Mode -
Cordless Scanner and Base
Daytime Mode -
Corded Scanner
* Green LED Flashes/Sound
Red LED Flashes/Silent