User Manual

Xenon XP User Guide 123
Out-of-Range Delay
Note: This setting is not supported by the Xenon XP 1950h scanner.
When using the Out-of-Range Alarm settings, the length of the delay for the alarm
is set with an Out-of-Range Delay. When the scanner is out of range of the base or
Access Point, the alarm will delay for a set length of time before going off. Set the
length (in seconds) for a timeout by scanning the following bar code, then setting
the timeout (from 0-3,000 seconds) by scanning digits from the Programming
Chart, beginning on page 309, then Save. Default = No Delay.
Scanner Alarm Volume
Medium
Base Alarm Volume
High
Scanner Alarm Volume
High
Out-of-Range Delay