User Manual

290 Xenon XP User Guide
Health Care Housing
Some configurations of Xenon scanners are available with an external plastic
housing that is designed to resist the effects of harsh chemicals in a health care
environment. The plastic is crystalline in nature, which helps prevent chemicals
from seeping through the housing.
Important! The following cleaning solutions have been tested to assure safe clean-
ing of your scanner’s disinfectant-ready housing. They are the only solutions
approved for use with these scanners. Damage caused by the use of cleaners other
than those listed below may not be covered by the warranty.
•Sani-Cloth
® HB wipes
•Sani-Cloth
® Plus wipes
• Super Sani-Cloth
® wipes
• Isopropyl Alcohol wipes (70%)
•CaviWipes
™
•Virex® 256
•409
® Glass and Surface Cleaner
•Windex
® Blue
•Clorox
® Bleach – 10%
• Gentle dish soap and water
Inspect Cords and Connectors
Inspect the interface cable and connector for wear or other signs of damage. A
badly worn cable or damaged connector may interfere with scanner operation.
Contact your distributor for information about cable replacement. Cable replace-
ment instructions are on page 290.
Replace Cables in Corded Scanners
The standard interface cable is attached to the scanner with an 10-pin modular
connector. When properly seated, the connector is held in the scanner’s handle by
a flexible retention tab. The interface cable is designed to be field replaceable.
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the
original interface cable.