User Manual

Xenon XP User Guide 291
Replace an Interface Cable
1. Turn off the power to the host system.
2. Disconnect the scanner’s cable from the
terminal or computer.
3. Locate the small hole on the back of the
scanner’s handle. This is the cable release.
4. Straighten one end of a paper clip.
5. Insert the end of the paper clip into the small
hole and press in. This depresses the retention
tab, releasing the connector. Pull the connector
out while maintaining pressure on the paper
clip, then remove the paper clip.
6. Replace with the new cable.
Insert the connector into the opening and press firmly. The connector is keyed
to go in only one way, and will click into place.
Replace Cables and Batteries in Cordless Systems
Replace an Interface Cable in a Base
1. Turn the power to the host system OFF.
2. Disconnect the base’s cable from the terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while maintaining pressure on the connector release
clip.
Cable
Release
CCB01-010BT
Base:
CCB-H-010BT Base: