User Manual

Xenon XP User Guide 47
Place the scanner in the base that is connected to an appropriate power supply.
Use only a Listed Limited Power Source (LPS) or Class 2 type power supply with
output rated 5 to 5.2Vdc, 1A.
Note: If you are powering the base through the interface cable (for example, a USB cable)
and not using an external power supply plugged into the aux port, the current
available for charging is reduced and charge times are increased.
Battery Information for the Xenon XP 1952g/1952h
Power is supplied to the Xenon XP 1952g or 1952h scanner by a rechargeable bat-
tery that is integrated in the scanner handle. Batteries are shipped only partially
charged. The battery should be charged for a minimum of 4 hours before initial use
to ensure optimal performance.
Battery Recommendations
• The battery is a lithium ion cell and can be used without a full charge, and can
also be charged without fully discharging, without impacting the battery life.
There is no need to perform any charge/discharge conditioning on this type of
battery.
• Keep the base connected to power when the host is not in use.
• Replace a defective battery immediately since it could damage the scanner.
• Although your battery can be recharged many times, it will eventually be
depleted. Replace it after the battery is unable to hold an adequate charge.
• If you are not sure if the battery or charger is working properly, send it to
Honeywell International Inc. or an authorized service center for inspection.
Refer to Customer Support on page xv for additional information.
Safety Precautions for Lithium Batteries
• Do not place batteries in fire or heat the batteries.
• Do not store batteries near fire or other high temperature locations.
• Do not store or carry batteries together with metal objects.
• Do not expose batteries to water or allow the batteries to get wet.
• Do not connect (short) the positive and negative terminals, of the batteries, to
each other with any metal object.
Caution: Use only Honeywell Li-ion battery packs, model number BAT-
SCN05, rated 3.7 Vdc, 7.4Whr in this device. Use of any non-
Honeywell battery may result in damage not covered by the
warranty.