User Manual

Xenon XP User Guide 49
Scanner Communication and Scanning
The following feedback is provided by the scanner and indicates communication
and scanning status.
Scanner Charge Pack Status
The following charge status feedback is provided by the scanner when the scanner
is out of the base and has been idle for 5 seconds.
Note: The number of scans was measured with a clearly printed UPC code in good light. The
approximate number of scans varies with changes in label quality, Symbology, and
environmental factors.
Base/Access Point Communication and Scanning
The following feedback is provided by the base (red LED) or Access Point (blue
LED) and indicates communication and scanning status.
LED Beeper Cause
Normal Operation
Red Flash None Battery Low or Charge Pack Low
Green Flash 1 Beep Successful communication or linking
Red, Blinking Razz or Error Tone Failed communication
Menu Operation
Green Flash 2 Beeps Successful menu change
Red, Blinking Razz or Error Tone Unsuccessful menu change
Scanner LED Scanner Beep Charge Level
Approximate Expected
Scans (see note)
Yellow 3 sets of flashes 2 short beeps per
flash
30% 100
Red 3 sets of flashes 2 short beeps per
flash
10% 50
LED Communication Condition
Off USB suspend
On continuously Power on, system idle
Short blinks in multiple pulses. Occurs while
transferring data to/from the RF module or
the Host port.
Receiving data