User Manual

54 Xenon XP User Guide
Page
Page Mode
By default, the page button on the base or Access Point pages the scanners associ-
ated with that base or Access Point. If you want the page button on your base or
Access Point to be disabled, scan the Page Mode Off bar code, below. When Page
Mode is off, the base or Access Point will no longer page scanners when the button
is pressed. The red LED on the base or blue LED on the Access Point will remain lit
to indicate that page mode is off. (This light will go out when the button is pressed,
then back on when it’s released.) Default = Page Mode On.
Note: If you are using a Xenon XP 1952h model, refer to Quiet Operations - LED and
Volume Settings on page 119 for additional Page Button settings.
Page Pitch
When you press the page button on the base or Access Point, the scanners associ-
ated with that base or Access Point will begin beeping (see Page Button on page
45). You can set the pitch of the paging beep for each scanner by scanning one of
the following bar codes. Default = Low.
External or Interface Cable
Power
External Power Only
* Page Mode On
Page Mode Off
* Low (1000 Hz)