User Manual

Xenon XP User Guide 71
Reset the Factory Defaults: All Application Work Groups
The following bar code defaults all of the work groups to the factory default set-
tings.
To see what the factory default settings are, refer to the table of Menu Commands,
beginning on page 244. The standard product default settings for each of the com-
mands are indicated by an asterisk (*).
Note: Scanning this bar code also causes both the scanner and the base or Access Point to
perform a reset and become unlinked. The scanner must be placed in the base, or the
Access Point linking bar code must be scanned to re-establish the link. Refer to
Scanner Modes, page 56 for additional information.
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping
while all scanners are relinked to the base or Access Point and the settings are
changed.
Group 4
Group 5
Group 6
Factory Default Settings:
All Work Groups
PAPDFT&